How To Make A Headband Holder

Michelle, The Fierce Glamour

I've been looking for a headband holder or how to make one for a long time? Well I didn't get any where with it so I decided to make my own. Here's how I made it!


I searched to find the exact headband holder that I could make easily with NO SEWING! And I did! (Thank you to a girl and a glue gun!….I used her tutorial, but tweaked it a little bit)


Supplies:

Large D Ring

1″ Wide Ribbon

(if you want another layer, 2″ Wide Ribbon)

Glue Gun and Glue Sticks

Scissors

Cut your ribbon as long as you think you need it. I cut my ribbon REALLY long, like 2 1/2 yards. I cut the 2″ ribbon long too and trimmed it later. I have ALOT of headbands.

Start by pinching about 3 inches of your 1″ ribbon. Flip this over and glue it together.

After that is cool, glue under the pinched part and lay it down flat. This creates your hook for the headbands.

Space about 4 to 4 1/2 inches between each pinched loop. This is so your headbands can hang evenly. No exact measurements were exactly taken; judge it.

Make enough loops till you run out of ribbon.

This is were I made a tweak. Glue your looped ribbon to the 2″ section. I glued the looped ribbon at the top then at each loop and the very bottom.

I left enough 2″ ribbon on the top to glue the D ring to it.

I pulled the two ribbons over and glued the D ring in between and then glued the end together. That's all it took! Finished!

Close up of finished project.

Finally…in use, out of the shoe box, and off the floor.

I picked this blue/black ribbon combo because it matches the color scheme of our bedroom. If you have a problem organizing your headbands. This is the perfect solution, easy to make, and takes about 30 min…less if you have more of a plan!


UPDATE: If you do make a headband holder, I would LOVE LOVE LOVE to see it. Please link it back to me! or email/twitter/facebook me with the link!!

Michelle, The Fierce Glamour


www.facebook.com/fierceglamourblog
http://twitter.com/fierceglamour

To find A Girl and a Glue Gun's tutorial: http://kimboscrafts.blogspot.com/2011/01/headband-holder.html